test2

Updated on Tue, 2008-05-13 17:09. Originally created by chajecki on 2008-05-13 17:06.

added by zibi

This may become a FAQ but since it came a few times, here is a run-down of the ways one could attach images to Drupal and their scope/usage restrictions. This was already treated to some extent into this thread (IMage assist / Image attach)in Hypernews and illustrated here.

Image as attachments

First, as stated in the Hypernews posting, attachments were never made to attach images because attachments is used to attach document such as talks, presentations and analysis related documents which needed (by requirements gathering) to be protected. Hence, attachments will not be accessible by non-authenticated users (and should not be).

An example of an image added as attachements is below -->

<--- end of attached image. This image is NOT visible for non-authenticated users as stated.

However, if your pages are intended for STAR users only in the first place (analysis notes, etc ...) this is a fine solution and it will not matter.

Images using image assists

Not user's preferred module, image assists allows lots of flexibilities including

arranging images into galleries, classifying by categories
allowing each image to be a stand-alone page (one can reference elsewhere)
allowing multiple formats (all done automatically) for images and thumbnails

The main issue users have had is the complexity (multiple steps) to add an image via this "ultimate possibilities" module. Typically, richness of possibilities and ease-to-use are orthogonal.

Here is the same image attached using the img_assit module.

Here is the same image attached

Thumbnail -->

Opteron yearly CPU usage

<---

img_assist causes a small formatting issue if you use the default (align=left) that is, whenever an image or thumbnail is included, the next paragraph (and until the spanning of the caption is passed and from the top of the imagfe) is indented. The end of the arrow marker (<-- ) to the end of this text illustrates the issue. Remember to change the "alignement" tab accordingly (set it to "none" to avoid this effect).